A SERVICE OF

logo

Open as PDF
next previous
Chapter 2—Operation 2-7
Accessing the Memory Sockets
1. Turn the system power off.
2. Press the two keyboard latches to elevate the keyboard from it normal position.
3. Carefully lift the keyboard assembly out so that the mainboard is exposed.
Locate the memory sockets (Figure 2-6/7).
Note:
l The memory socket Bank is a reverse type, make sure you install the
memory module with reverse side to fit its connector.
l Please ensure that each edge of the memory module (SDRAM) has no
component mounted on (see Figure 2-6). It is recommended to use the
RAM module that complies with Intel unbuffered SO-DIMM
(67.6mmX31.75mm). Please consult your dealer for detailed information.
Figure 2-9
Figure 2-6
Figure 2-7
Non-component area
(The edges of the memory module are
the non-component area.)
Bank 0 Bank 1
67.6mm
31.75mm