%*+##+ &%
'&.)S$* %#. ))
)A4AF;5*7?;GFA?3F;5*KEF7?
• Use the bench feeder for offline welding.
Shown with
• K2230-1 Power Feed™ 10M Single Wire Feeder
• K1780-2 PF-10/R
• K2203-1 Power Wave 455M/STT
• K2205-1 Wire Drive Module
$G>F;B>7.;D77767D*KEF7?
• Load one feeder with solid wire, the other with flux
cored.
• Great for pipeline work.
Shown with
• K2429-1 ArcLink T Cable Connector
• K2196-1 Power Feed 15M
• K2203-1 Power Wave 455M/STT
D5#;@=*KEF7?E
Many other ArcLink systems may be assembled
besides those shown in this manual. The majority will
self configure. If an assembled system flashes the sta-
tus light green rapidly on all components, contact the
Lincoln Electric Company for further assistance.
Current Power Feed™ 10M models that will not self
configure...
• K2316-1 Power Feed™ 10M Dual Boom
These configurations will require Dip Switches to be
set. See the power source instruction manual on how
to disable self configuration.
/$'#* & &%%+ % %
)# %"'&.).-*0*+$
ArcLink Power Wave products may be configured in
many different ways. The flexible system allows multi-
ple wire feeders to be connected to the same power
source. The diagrams represent some of the common
methods for connecting ArcLink Products.
Important: Bench model wire feeders cannot be sepa-
rated into a separate control box and wire drive for a
boom system.
Common ArcLink Systems
The following Power Wave systems may all be
assembled without any changes to the equipment DIP
switches
3E;5*7?;GFA?3F;5*KEF7?
• Great for general fabrication.
Shown with
• K2230-1 Power Feed™ 10M Single Wire Feeder
• K2203-1 Power Wave 455M/STT
AA?*7?;GFA?3F;5*KEF7?
• Often used when making large weldments.
Shown with
• K2314-1 Power Feed™ 10M Single Wire Feeder
Boom (includes wire drive and control box)
• K2203-1 Power Wave 455M/STT
