&')+ &%
+$ *) '+ &%
1 Status LED indicates system status.
2 Digital Meter Display is a bright LED display of key welding information. Adjusting Parameter Knobs.
3 MSP4 Panel is used to set the weld mode, adjust the arc, change arc start/end parameters and for set-
up information.
4 Cold Feed - Gas Purge Switch, press the switch up to feed wire with weld output off. Press the switch
down for gas flow with weld output off.
5 2 step - 4 step Switch is used to choose between a 2 step trigger or a 4 step trigger operation.
6 Memory Panel. Operating Instructions are located in this &B7D3F;A@*75F;A@if your machine is equipped
with this unit. If not equipped you may order K2360-1 Field-Installed option (See 557EEAD;7E*75F;A@).
(Memory Panel are for Codes 11771, 11772 and above)
7 Cover for Optional Water Cooling Kit, remove when the water cooling kit is installed. See instructions
with water cooling Kit.
8 Trigger Connector 5-pin amphenol for connecting the MIG gun trigger. See Installation Section for detail.
'&.)S$* %#. ))
)&%+'%#&%+)&#*%&%%+ &%*
CASE FRONT CONTROLS
,)
