Part Names and Functions
Rear Terminal
① ② ③ ④
⑤
⑥ ⑦ ⑧ ⑨ ⑩
⑪
⑦
R/C JACK
When using the wired remote control, connect
the wired remote control to this jack with a
remote control cable (not supplied) (p.15).
⑧
USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with a USB cable (p.20).
⑨
CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable (p.20).
①
HDMI TERMINAL
Connect the HDMI signal from video equipment
or the DVI signal from computer to this terminal
(pp.20, 21).
is registered trademarks of HDMI Licensing, LLC.
②
COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output
signal to this terminal (pp.
20, 21
).
③
COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output digital signal to
this terminal. The HDTV (HDCP compatible)
signal can also be connected (pp.
20, 21
).
⑥
VIDEO INPUT JACK
Connect the component or the composite video
output signal from video equipment to these
jacks (p.21).
④
MONITOR OUT TERMINAL
This terminal can be used to output the
incoming analog RGB signal from INPUT 1-3
terminal to the other monitor (pp.
20, 21
).
⑤ 5 BNC INPUT JACKS
Connect the component or composite video
output signal from video equipment to VIDEO/Y,
Pb/Cb, and Pr/Cr jacks or connect the computer
output signal (5 BNC Type [Green, Blue, Red,
Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V,
and V jacks (pp.
20, 21
).
⑩
S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).
Kensington Security Slot
This slot is for a Kensington lock used to deter
theft of the projector.
*Kensington is a registered trademark of ACCO
Brands Corporation.
⑪
LAN CONNECTION TERMINAL
Connect the LAN cable (refer to the owner’s
manual of “Network Set-up and Operation”).
