Sanyo PLC-HP7000L Manual

A SERVICE OF

next previous

Note:

 •FactorydefaultisOFF: 5 Min.

 •WhentheshutterisclosedwhilethePowermanagement

functionisworking,thePowermanagementfunctionis

released.

Setting

Timer left before Lamp is off.

Power management

For reducing power consumption as well as maintaining

the lamp life, the Power management function turns off the

projection lamp when the projector is not operated for a

certain period.

Select one of the following options:

Ready 1 ........... When the lamp has been fully cooled

down, the POWER indicator changes

to green blinking. In this condition, the

projection lamp will be turned on if the

input signal is reconnected or any button

on the side control or remote control is

pressed.

Ready 2 ........... When 3 hours have elapsed since power

management has been carried out, the

lamp will turn off and the power will switch

off. The operations during the initial 3

hours are the same as for Ready 1.

Shut down ...... When the lamp has been fully cooled

down, the power will be turned off.

Off ................... Power management function is off.

Timer ............... If the input signal is interrupted and

no button is pressed for more than 30

seconds, the timer display with No signal

appears. It starts the countdown until the

lamp is turned off. Use the Point

▲▼

buttons to set the Timer (1~30 Min).

Power management

When this function is set to On, the projector will be

automatically turned on just by connecting the AC power

cord to the wall outlet.

Note:

Besuretoturnofftheprojectorproperly(see“Turning

OfftheProjector”onpage24).Iftheprojectoristurned

offintheincorrectsequence,theDirectonfunction

doesnotworkproperly.

Direct on

63