3Network Installation
20 Xerox WorkCentre 4260 Series System Administration Guide
DHCP/DDNS:
• Release Registration – Allows DHCP resources to be released when the machine is
powering down. This is a display-only item and shows “Enabled”.
Zero-Configuration Networking:
• Self Assigned Address (IPv4) – Allocates an IPv4 address without using a DHCP
server. This check box is selected when [IP Address Resolution] is set to [Autonet].
This is a display-only item.
• Self Assigned Address (IPv6) – Displays “Enabled”. This is a display-only item.
SNMP Configuration
Allows you to configure the following options when accessing the machine via SNMP.
SNMP Properties:
Enable SNMP v1/v2c Protocols – Allows you to enable or disable the SNMP v1/v2c protocols.
Edit SNMP v1/v2c Properties – Displays the page which allows you to set the following SNMP
v1/v2c properties.
Community Names:
• Community Name (Read Only) – Enter the community name used for display.
• Community Name (Read/Write) – Enter the community name used for display and
update.
Default Trap Community Name:
• TRAP Community Name – Enter the trap notification community name.
System Administrator’s Login ID:
• System Administrator’s Login ID – Enter the ID of the System Administrator.
Enable SNMP v3 Protocol – Allows you to enable or disable the SNMP v3
protocol.
Edit SNMP v3 Properties – Displays the page which allows you to set the
following SNMP v3 properties.
This button is active only when the Secure HTTP (SSL) feature is enabled.
Administrator Account:
• Account Enabled – Select to enable the System Administrator’s account.
• User Name – Displays the user name of the System Administrator.
• Authentication Password (minimum 8 characters) – Enter the authentication
password using 8 to 32 characters.
• Confirm Authentication Password – Re-enter the authentication password for
verification.
