4635 LPS HARDWARE COMPONENTS
9. Printer icon. Select this icon to display the printer mimic.
(This is the default display on the printer control console.)
10. Language icon. Select this icon to choose the language for
the printer control console messages.
11. Message area, used as follows:
• Lines 1 and 2. These lines display the current status of
the printer, for example, READY.
• Line 3. This line displays messages concerning masked
conditions, such as low dry ink. These messages are
preceded by an asterisk.
• Line 4. This line displays messages that originate at the
system controller.
12. Area where the following icons appear:
Hint icon. This icon appears when a masked fault or
condition exists in the printer. (Refer to the Xerox 4635 LPS
Operator Guide, “Fault masking and the printer control
console” section.) The icon also appears on the PC UI.
Fault icon. This icon appears only when a fault exists in the
system that stops the printer or prevents it from printing.
The icon also appears on the PC UI.
ACT icon. This icon appears when a maintenance task
requiring an ACT trained operator must be performed. If you
have successfully completed ACT, either check the PC UI for
messages concerning the maintenance task or touch the
Guarded Tools icon to display the Guarded Tools screen. If
you are not an ACT trained operator, notify your lead
operator or an ACT trained operator at your site.
Note: The bypass transport is optional and appears on the
printer control console of those systems that are configured as
such.
Attention light
An attention light is mounted on top of the inverter module.
(Refer to figure 3-6.) The attention light can be enabled or
disabled. (Refer to the Xerox 4635 LPS Operator Guide for
instructions.) When enabled, the light has three states:
• Off. No printer problems exist that require your attention.
• Steady light. A situation exists that needs your attention
(such as a low dry ink condition).
• Flashing. The printer has stopped and your attention is
required immediately.
Attention alarm
An attention alarm is located within the printer. Like the
attention light, the attention alarm is enabled and disabled by the
operator (refer to the Xerox 4635 LPS Operator Guide). When
enabled, the alarm has two states:
• Off. No printer problems exist that require your attention.
• Beeping. The printer has stopped and your attention is
required immediately.
3-8 XEROX 4635 LASER PRINTING SYSTEM PRODUCT REFERENCE
