Filter
Top Products
29-EN
Adjusting and Storing the
Equalizer Curve
You can modify the Equalizer settings to create a
response curve more appealing to your personal
taste.
1 Select the equalizer characteristic to adjust. See
"Equalizer Presets" (on page 28).
2 Press the MODE button. The Frequency band
indication in the display flashes.
3 Rotate the Audio Control knob to adjust to your
desired level.
4 Press the MODE button to flash the next
frequency band indication.
5 Rotate the Audio Control knob to adjust to your
desired level.
6 Repeat the steps 4 to 5 above until all the
frequency bands (16 kHz) are adjusted.
To store the adjusted contents
1) Press and hold the MODE button for at least 2
seconds.
The display flashes and you can store the
adjusted curve.
(When pressing one of the 1 - 6 buttons, you
can also store the adjusted curve.)
2) While the display is blinking, press one of the
1 - 6 buttons that you want to store.
NOTE
The contents of DHE/EQ can be stored. (The settings of
LPS are not stored.)
7 Press the DSP button to select OFF to return to
normal mode.
NOTE
You can also select the frequency band to be adjusted by
pressing the g DN button or f UP button.
Recalling the Stored Equalizer
Curve
1 Press the DSP button to select EQ MEMORY
mode.
2 Press the g DN button or f UP button to
select your desired curve form the MEMORY 1 -
MEMORY 6.
Direct select
Press one of 1 - 6 buttons to activate your
desired curve.
(If you select the PRESET 2)
3 Press the DSP button to select OFF to return to
normal mode.
NOTE
This function is inoperable when DEFEAT is ON (refer
to page 9).
Choosing the Listening Position
Selector (L.P.S.)
This feature gives the user the ability to adjust the
time delay of the 4 main speakers to provide the
ideal sound stage for each listener in the car. The
staging can be optimized for the front passenger,
driver, front passenger and driver, or front and
rear passengers and driver.
1 Press the DISP button to select LPS mode.
2 Press either g DN button or f UP button.
The seat position will change every time the
button is pressed.
Select the desired seat position.
Direct select
Press the desired button from the 1 - 5 buttons.
[1] : OFF [4]: FRONT-L
[2] : ALL [5]: FRONT-R
[3] : FRONT
3 Press the DSP button to select OFF to return to
normal mode.
NOTE
You cannot use the L.P.S. and Time Correction at the
same time.
→ EQ ←→ EQ MEMORY ←→ LPS ←→ OFF ←
→ EQ ←→ EQ MEMORY ←→ LPS ←→ OFF ←
→ EQ ←→ EQ MEMORY ←→ LPS ←→ OFF ←
→ FRONT-R ←→ FRONT-L ←
→ OFF ← → ALL ← → FRONT ←
→ EQ ←→ EQ MEMORY ←→ LPS ←→ OFF ←