Filter
Top Products
43-EN
Installation
Caution
When you install this unit in your car, do not remove
the Detachable Front Panel.
If the Detachable Front Panel is removed during
installation, you might press too hard and warp the
metal plate that holds it in place.
Caution
Do not block the unit’s fan or heat sink, thus
preventing air circulation. If blocked, heat will
accumulate inside the unit and may cause a fire.
1
Slide mounting sleeve from main unit (see
"Removal" on this page). Slide the mounting
sleeve into the dashboard.
2
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the CDA-
7878R and put the Rubber Cap on the hex bolt.
If your vehicle does not have the Mounting
Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the
leads of the CDA-7878R according to details
described in the CONNECTION section.
Metal plate
Detachable
Front panel
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push
the locking pins to the “up” position (see above
drawing). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock before
unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do
so.
<JAPANESE CAR>
Face Plate
NOTE
Secure the ground lead of the unit to a clean metal spot
using a screw (
∗
) already attached to the vehicle's
chassis.
Mounting Bracket
Ground Lead
Screws (M5 × 8)
(Included)
CDA-7878R
∗
Air ventilation
hole
<Rear side>
NOTE
For the screw
*
, provide a proper screw to the chassis
installing location.
3
Slide the CDA-7878R into the dashboard. When
the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done
by pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
Lock pin
∗
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
Dashboard
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
Hex Bolt
(Included)
CDA-7878R
CDA-7878R