Filter
Top Products
20-EN
Retrieving an addressee by Selecting Search (A-Z search)
3
Press 8 or 9 to select an initial letter (A to Z) of the
addressee.
4
Turn the Rotary encoder to select the addressee.
5
Press :/J or Rotary encoder to place a call.
6
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If all telephone numbers and registered names cannot be displayed
at once, press DISP/TITLE to show undisplayed numbers and
names.
• “NO MEM” is displayed if nothing is registered in the Phone
Book.
Calling by using the Speed Dial
You can place a call by retrieving one of the telephone numbers
registered in No. 1 to 9 of the address book.
1
Press and hold BAND/TEL. for at least 2 seconds.
2
Within 5 seconds, place a call by pressing and
holding the desired preset buttons (1 through 6)
for at least 2 seconds.
By pressing F/SETUP, and then pressing a preset
button (1 through 3) for at least 2 seconds, you
can place a call to the number registered in 7 to 9.
•You can place a call by pressing :/J after momentarily pressing
the preset button (1 through 6) of the number you wish to call.
•You can place a call by pressing the Rotary encoder, after selecting
a number which you wish to call, by pressing g or f , or by
turning the Rotary encoder.
3
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If there is no telephone number registered to a preset button, “NO
P-SET” is displayed when you try to place a call.
Calling by the outgoing/incoming/absent incoming history
You can place a call to any of the last 999 calls by the outgoing/
incoming/absent incoming history.
1
Press SEARCH/QS in PHONE BK (Phone Book)
mode to select the History mode.
2
Press 8 or 9 to select outgoing history (display
example: “DIALED”), incoming history (display
example: “RECEIVED” ), absent incoming history
(display example: “MISSED”).
3
Turn the Rotary encoder, or press g or f to
select the addressee from the outgoing or
incoming history.
4
Press :/J or the Rotary encoder to place a call.
5
Press BAND/TEL. to end the call.
Telephone mode will end and return to the original source
mode.
• If all telephone numbers and registered names cannot be displayed
at once, press DISP/TITLE to show undisplayed numbers and
names.
• “NO MEM” is displayed if there is no incoming history.
SMS (Short Message Service) Operation
You can be informed when you receive a short message.
Receiving a short message
1
When a text message is received, “NEW MSG” is
indicated on the display.
The contents of the received message can only be read
from the portable phone's display.
2
Press any one of the buttons on the unit to cancel
the display. The buttons that are pressed will enter
the mode or will be activated.