Alpine IVA-D100 Car Stereo System User Manual


 
9-EN
01GB05IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
Accessory List
Monitor unit..........................................................................1
Power Amplifier....................................................................1
DC/DC Converter ................................................................1
Power Cable........................................................................1
Amplifier Cable....................................................................1
RCA Extension Cable..........................................................2
Mounting Sleeve..................................................................1
Mounting Bracket................................................................2
Flush Head screw (M4 x 3)..................................................8
Hexagon washer-head screw (M4 x 6)................................4
Screw (M4 x 8).....................................................................4
Flange-head tapping screw (M4 x 14)................................2
Hexagonal screw (M4 x 15).................................................4
Velcro Fastener....................................................................2
Front Frame .........................................................................1
Remote Control....................................................................1
Battery (CR2025).................................................................1
Carrying case......................................................................1
Owner's Manual.............................................................1 set
Location of Controls
Rotary encoder/MUTE/MODE
Adjust the volume by turning to the left or right.
Turns the Mute mode on or off by pressing repeatedly.
If pressed and held for at least 2 seconds, the audio
adjusting screen is displayed.
Remote Sensor
Point the supplied remote control transmitter towards the
remote sensor within a range of 2 meters.
SOURCE/POWER button
Turns the power on. Press and hold for at least 2 seconds to
turn the power off.
Monitor open: Recalls the source selection screen.
Monitor closed: Changes the source.
BAND/SAT button
Radio mode: Changes the band.
Visual source (except navigation screen): Changes the
display mode.
Press this button for at least 2 seconds to recall a weather
channel or traffic channel. Note however, this setting can be
made only if the XM or SIRIUS Receiver Box is connected.
VISUAL button
Press and hold for at least 2 seconds to recall the VISUAL
selection screen.
If VISUAL is set in “Setting the VISUAL Button” (page 36),
momentarily press to recall the VISUAL selection screen,
and if NAV. is set, momentarily press to recall the navigation
screen.
Visual Indicator
Lights up in simultaneous mode.
SETUP button
Recalls the SETUP selection screen.
OPEN/CLOSE/FLAT button
Opens the monitor. Closes the monitor by pressing and
holding for at least 2 seconds.
Press to set the open monitor to the flat position.
button
Ejects a disc.
button
Use this button to remove the front panel.
DISC IN Indicator
Lights up when a disc is inserted in the unit.
Guide Indicator
The indicator is constantly lit, other than for the following
indicators.
The indicator blinks when closing the monitor.
The indicator is turned off when the dimmer (monitor
display brightness) is set to ON, and is also turned off
according to the brightness of the car when the dimmer
is set to AUTO.
If ON is set in “Setting the Brightness of the Backlighting”
(page 37), the brightness is set by adjusting in “Adjusting
the Dimmer of Button Lighting at Night” (page 34).
However, if the level is set to “-2”, the guide indicator
turns off.
The indicator slowly blinks when the backlighting (BLACK
OUT function) is set to OFF.
The indicator blinks in the voice guidance mode when an
ALPINE navigation system is connected.
Disc Guide Indicator
Lights up when power is turned on.
Getting Started
About the expression of buttons in this Owner’s
Manual
The buttons on this unit are expressed in bold (e.g. SOURCE/
POWER). The touch buttons on the display are expressed in bold
with [ ] (e.g. [BAND]).
01GB00IVAD100.book Page 9 Tuesday, February 14, 2006 4:10 PM