Filter
Top Products
36-EN
01GB05IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
Outputs the picture of the source selected on the IVA-D100 connected
to the rear monitor.
Setting item: AUX OUT
Setting content: OFF / ON
Setting item: VISUAL KEY
Setting content: VISUAL / NAV.
Setting item: SUBW. OUT
Setting contents: ON / OFF
To connect an audio processor using the optical digital output, set to
“ON” by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The setting
of Digital Output is decided.
Display Setup Operation
1
Press SETUP.
The SETUP selection screen is displayed.
2
Touch [] of OTHER SETUP.
The OTHER SETUP screen appears.
3
Touch [] of DISPLAY SETUP.
The DISPLAY setup screen appears.
4
Touch [] or [] etc., of the desired item to change
its setting.
Setting items:
DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO
BACKGROUND / BASE COLOR / PULSETOUCH /
SCREEN ALIGNMENT
5
Touch [RTN] to return to the previous screen.
• Immediately after changing the settings of Display Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF.
Otherwise, the settings may not be changed.
Setting the Picture Output
ON: The "REAR SELECT" item is displayed on the SETUP
select screen.
Touch [ ] of REAR SELECT to change to the REAR
select screen, then touch [ ] of the desired source. The
selected source picture is output on the rear monitor.
OFF: The "REAR SELECT" item is not displayed on the SETUP
select screen.
Setting the VISUAL Button
NAV.: Switches directly to the navigation screen by pressing
VISUAL. (Only when an Alpine optional RGB
Navigation is connected.)
VISUAL: Recalls the VISUAL Select screen by pressing
VISUAL.
Subwoofer On and Off
ON: Subwoofer output is on.
OFF: Subwoofer output is off.
Setting the Digital Output
DISPLAY Setup
To display the Display mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Display mode operation has been
released. Engaging the parking brake can reactivate the Display
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To display the Display mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the Display mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of DISPLAY Setup. Refer to each section for
details.
01GB00IVAD100.book Page 36 Tuesday, February 14, 2006 4:10 PM