Filter
Top Products
128-6566
2 of 20
INSTINST
INSTINST
INST
ALLALL
ALLALL
ALL
AA
AA
A
TT
TT
T
ION INSTRUCION INSTRUC
ION INSTRUCION INSTRUC
ION INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
22
22
2
INSTINST
INSTINST
INST
ALLALL
ALLALL
ALL
AA
AA
A
TT
TT
T
ION INSTRUCION INSTRUC
ION INSTRUCION INSTRUC
ION INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
INSTALLATION INSTRUCTIONS
This unit is designed to fit into a double-DIN dashboard opening (approximately 7.0 x 3.9” (178
x 100 mm)), found in many imported cars. The unit has threaded holes in the chassis side
panels which may be used with the original factory mounting brackets of some Toyota, Nissan,
Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount the radio to the dashboard. For
assistance or answers to installation problems, call Audiovox toll-free at 1-800-645-4994
(Continental U.S./Canada only), or consult with your local car stereo specialist shop.
1. Remove the existing factory radio from its dashboard or center console mounting.
Save all hardware and brackets as they will be used to mount the new radio.
2. Remove the factory mounting brackets and hardware from the existing radio. Attach
the mounting brackets to the new radio using the M5 x 5mm screws supplied with the
ACD-95. DO NOT USE THE SCREWS FROM THE FACTORY RADIO.
CAUTION : DO NOT EXCEED M5 X 5 MM MAXIMUM SCREW SIZE.
LONGER SCREWS MAY TOUCH AND DAMAGE COMPONENTS
INSIDE THE CHASSIS.
3. In most installations, it is more convenient to complete the wiring before mounting the
radio in the dashboard. Follow the wiring diagram carefully and make certain all
connections of the wiring harness are secure and insulated with wire nuts or electrical
tape to insure proper operation of the unit. After completing the wiring
connections, plug the 14-pin connector into the mating socket on the rear of the
chassis, attach the front panel, and turn the unit on to confirm operation (ignition
switch must be “on”). If unit does not operate, re-check all wiring until problem is
corrected. Once proper operation is achieved, turn off the ignition switch, unplug
the wiring harness from the chassis, and proceed with final mounting of the chassis.