Filter
Top Products
128-6838
7 of 16
-7-
Shuffle Play mode, pressing the Forward Track Select ( ) or
Backward Track Select (
) will also select tracks in a random
order instead of the normal progression. Additional presses will select
tracks in random order. The Shuffle Play mode can be cancelled by
pressing the button again (S--SHF) indication will disappear from
the display panel) or by activating the Repeat Play
cp or Track Scan cr
functions.
cr TRACK SCAN (SCN)
During disc play, press this button to play the first 10 seconds of each
track on the disc (S--SCN will appear on the display panel with the track
number). When a desired track is reached, press the Scan button
again to cancel the function and play of the selected track will continue.
Track Scan mode will also be cancelled by activating the Repeat Play
cp or Shuffle Play cq functions.
cs DISC SELECT UP/DOWN (CD-/CD+)
These buttons are used to select the desired disc for play during changer
operation. To advance to a higher number disc, press the CD+ button, and to
return to a lower number disc, press the CD- button. The number of the disc
in play will be shown on the display panel.
ct DISC EJECT ( )
When this button is pressed, disc play is stopped, the disc is ejected
and the unit will change to radio operation. If the disc is not removed
from the unit within 15 seconds, the disc will be reloaded ( will
reappear).
cu MODE SELECTOR (MODE)
During radio play, press the MODE button to select operation of the CD
Player or the optional CD changer. Refer to the CD Changer Controls
section for specific operating instructions.
If the button is pressed when no CD changer is connected to the unit,
no changer indications will appear on the display panel. The unit will
then return to radio operation. To return to CD Player operation (if a disc
is loaded in the unit), press the button again. During disc play, press
this button to change to radio operation without ejecting the disc. On
the P-956G radio, pressing and holding this button (ILL/MODE) for 2
seconds will change the LCD backlighting (Illumination) between
Green and Amber.
dl TIME/FREQUENCY SELECTOR (T/F)
Pressing the Time/Frequency (T/F) button will display the time of day
for 5 seconds, after which the display will automatically return to the
radio, CD Player or CD changer display, depending on which mode
was currently active. To set the correct time of day, refer to the procedure
for Setting the Clock.
dm THEFT-DETERRENT LED
Located on the chassis behind the front panel, a light-emitting diode
(LED) will flash when the panel is removed. The flashing light serves
as a visual warning to the would-be thief that the unit has been disabled
by removal of the front panel.
dn RESET BUTTON
A RESET button is located on the front of the chassis (front panel must
be removed to access the button). The re-set circuitry is provided to
protect the microprocessor circuitry and should only be activated under
the following circumstances as it will erase the time and pre-set
memories.
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and return to
normal operation.
do FRONT PANEL RELEASE BUTTON
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button so that
the left side of the panel is released. Grasp the released side and pull
it off of the chassis. To re-attach the panel, position the right side of the
panel in place first and then press the left side of the panel until the
mechanism locks it into place.