Filter
Top Products
7
Charging the battery
The rechargeable battery enables the Lucca
to be operated without requiring an external
source of power. The battery must be fully
charged (by recharging it for approx. 5 to 6
hours) to achieve the maximum battery run
time of up to 3 hours.
The battery charge indicator is always
displayed in the top centre of the screen
no matter whether you are navigating or
using the Music Player or Picture Viewer.
The battery charge indicator will display the
following symbols:
: Lucca is connected to an external
power source.
: Lucca is running on its internal
battery. The battery has suffi cient
charge.
: Lucca is running on its internal
battery. The battery is running low.
The number of dark blocks shown inside
the battery indicates the charge left (0 to
3 blocks).
NB:
Lucca will issue a warning if the battery
is running very low.
The battery can be recharged using
either the supplied charger cable for
the cigarette lighter or the optionally
available charger.
NB:
Only use Blaupunkt-approved chargers.
Please contact your Blaupunkt dealer
for more information on Blaupunkt-
approved chargers.
Never dispose of defective battery
chargers as domestic waste!
“designated” collection points.
•
•
•
➜
•
•
Installing the Lucca into a
car
The Lucca is equipped with a suction cup
holder, which is designed for fastening to a
windscreen, to enable it to be temporarily
installed into a vehicle.
Caution:
Make sure that the Lucca is not installed
in such a way as to obstruct your view or
distract from the surrounding traffi c.
Do not install the Lucca within range of the
airbags.
Always make sure that the Lucca does not
represent a hazard to vehicle passengers
once installed in the event of emergency
braking.
Attaching the suction cup holder
The supplied suction cup holder enables
you to install the Lucca easily and safely into
your vehicle.
Choose a place suitable for installing the
Lucca on your windscreen.
The windscreen must be free from dust
and grease to ensure optimum adhesion.
If required, clean the windscreen before
installation using a special windscreen
cleaning cloth.
Press the adhesive plate of the suction
cup against the windscreen.
Fold the arm on the adhesive plate
towards the windscreen.
Adjust the suction cup holder. When
doing so, make sure that the bar for
attaching the Lucca is horizontal.
Removing the suction cup holder
The suction cup holder can be removed
easily if you are changing vehicles.
Move the arm on the adhesive plate away
from the windscreen.
Remove the adhesive plate carefully from
the windscreen at its edge so as to allow
air to enter into the space between the
adhesive area and windscreen.
Carefully pull the suction cup off the
windscreen.
➜
➜
➜
➜
➜
➜
➜
➜
Recharging the battery Installing the Lucca into a car
Lucca3_3RU_long_GB.indd 7Lucca3_3RU_long_GB.indd 7 11.07.2007 16:50:57 Uhr11.07.2007 16:50:57 Uhr