Blaupunkt MODENA CD50 Car Stereo System User Manual


 
33
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Adjusting seek tuning sensitivity
It is also possible to adjust the sensitiv-
ity of the seek tuning function to tune
the radio into stations with strong recep-
tion signals only, or to those with weak-
er reception signals as well.
Press MENU 8.
Press : repeatedly until
“SENS” appears in the display.
Press :.
The currently selected setting will ap-
pear in the display. “SENS HI6” indicates
the highest level of sensitivity, “SENS
LO1” the lowest. If you select “SENS
LO”, “lo” will light up in the display.
Press : to adjust the desired
sensitivity.
Once you have made your selec-
tion, press MENU 8 or OK ;.
Storing radio stations
Storing radio stations manually
Select the desired memory bank
FM1, FM2, FMT or either MW or
LW (the Sylt CD50 does not in-
clude MW/LW radio).
Tune the radio into the desired sta-
tion.
Press and hold down one of the
station preset buttons 1 to 6 > on
which you want to store the radio
station for longer than two seconds.
Storing radio stations
automatically (TravelStore)
You can automatically store the six ra-
dio stations with the strongest reception
in your current reception area (for FM
only). These stations will be stored in
the FMT memory bank.
Note:
Any stations stored previously in the
memory bank will be deleted.
Press and hold down BND / TS 5
for longer than two seconds.
The storing process will begin. “TRAV-
EL-STORE” will appear in the display.
After the stations have been stored, the
radio will automatically begin to play the
station stored on preset button 1 for the
FMT memory bank.
Recalling stored radio stations
Select the desired station memory
bank.
Press the station button 1 to 6 >
on which you have stored the de-
sired radio station.
Scanning the radio stations
within reception range (SCAN)
You can scan all of the radio stations
currently within your reception range.
The scan time can be set in the menu
to play from five to 30 seconds.
Starting SCAN
Press and hold down OK ; for
longer than two seconds.
SCAN will begin. “SCAN” will appear
briefly in the display, followed by the
RADIO OPERATION