Filter
Top Products
E - 3
Installation
INSTALLATION CAUTION
1. Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and
system workproperly.
2. Use only the parts included with the unit to
ensure proper installation. The use of un-
authorized partscan causemal functions.
3. Consult with your nearest dealer if install-
ation requires the drilling of holes or other
modifications ofthe vehicle.
4. Install the unit where it does not get in the
driver's way and cannot injure the
passenger if there is a sudden stop, like an
emergency stop.
5. If installation angle exceeds 30° from
horizontal, the unit might not give its
optimum performance.
6. Avoid installing the unit where it would be
subject to high temperature, such as from
direct sunlight, or from hot air, from heater,
or where it would be subject to dust dirt or
excessive vibration.
7. Be sure to remove the front panel before
installing theunit.
Installation with the half sleeve
After inserting the half sleeve into the
dashboard, select the appropriate tab
according to the thickness of the dashboard
mterial and bend them inwards to secure the
holder inplace.
182
111
Dashboard
Half
Sleeve
Screw
Attach the trim ring
Trim ring
Installation using the screw
holes on the side of the unit
Select a position where the screw holes of the
bracket and the screw holes of the main unit
become aligned (are fitted) and tighten the
screws at2 placeson eachside.
Note: The outer trim ring,and
half-sleeve are not used for this
installation.
Screw
Screw
Factory
radio
mounting
bracket
Dashboard or
console
Hook
Hook
Note: The mounting box, metal
half sleeve, hook & screws are
not included in the packnig.
RESETTING THE UNIT
After releasingthe front panel,use astick or any
non-metalic object to press & hold the reset
button forfive secondsto resetthe unit.
Reset Button