Filter
Top Products
VRX835 39
English
Owner’s manual
DSP operations
4. After the setting, press the [A-M] button
again or touch the [RTN] key to return to the
STANDARD display.
Note:
• If the VSE effect is set to OFF, the adjustment
made in “VSE operations” is not reflected in the
music source.
Calling VSE BASIC Pattern/USER
Pattern
1. Press the [A-M] button to show the AUDIO-
MODE display.
2. Touch the [VSE BASIC] and [VSE USER]
key to show BASIC pattern selecting display
or USER pattern selection/memory display.
3. In the pattern selecting display, touch the one
of pattern key to call corresponding VSE pat-
tern.
In this display, pressing the No. button in cor-
responding to the [DIRECT] key can also call
the VSE pattern.
∗ After selecting the VSE pattern, touch the
[MEMO] key to copy the selected pattern to
the USER pattern.
∗ Touch the [EDIT] key to show VSE adjusting
display, in which the properties of currently
selected pattern can be adjusted.
∗ By pressing the [BAND] button in BASIC
pattern selecting display or USER pattern
selection/memory display you can switch
between the two patterns, BASIC and USER.
4. After the selecting, press the [A-M] button
again or touch the [RTN] key two times to re-
turn to the STANDARD display.
Setting and storing VSE Properties/
Memory into USER Pattern
1. Repeat the steps 1 and 2 of the previous
procedure (Calling VSE BASIC Pattern/
USER pattern) to show BASIC pattern se-
lecting display or USER pattern selection/
memory display.
2. Touch the [EDIT] key to show the VSE ad-
justing display.
3. Select an item to be adjusted by touching
[ITEM] key in the VSE adjusting display.
The VSE adjustment contents are as follows:
●“CAR LENGTH”
Compensates for the length of the car‘s inte-
rior (longitudinal direction).
●“CAR WIDTH”
Compensates for the width of the car’s inte-
rior (lateral direction).
●“DIFFUSE”
Compensates for special impression.
4. Touch the [w] or [z] key to make the ad-
justment.
The adjustment range is to 1 to 10 for each
time.
5. After making adjustments to a desired pat-
tern by repeating the steps 3 and 4, touch
the [RTN] key to change over to the BASIC/
USER pattern selection/memory display.
6. Press and hold one of [DIRECT] button for 2
seconds or longer to store the adjusted VSE
pattern to the USER memory.
7. To set a title of the stored USER pattern,
touch the [TITLE] key to change into the
[TITLE INPUT] key.
∗ For title inputting method, refer to the section
“Entering titles”.
8. Press the [A-M] button to change into the
STANDARD display.
Professional mode/P.EQ
operations
P.EQ effect ON/OFF
∗ The factory default setting is “ON”.
1. Press the [A-M] button to show the AUDIO-
MODE display.
2. Touch the [P.EQ ON/OFF] key to select “on”
and “off”.
3. Each time the [ON/OFF] key is touched, the
on and off statuses are switched alternately.
4. After the setting, press the [A-M] button
again or touch the [RTN] key to return to the
STANDARD display.
Note:
• If the P.EQ effect is set to OFF, the adjustment
made in “P.EQ operations” is not reflected in the
music source.