Filter
Top Products
Back to Contents Page
Appendix
Dell™2407WFP-HC Flat Panel Monitor
FCC Identification Information
Safety Instructions
Contacting Dell
FCC Identification Information
FCC Class B
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's instruction
manual, may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference with radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:
l Reorient the receiving antenna.
l Relocate the system with respect to the receiver.
l Move the system away from the receiver.
l Plug the system into a different outlet so that the system and the receiver are on different branch circuits.
Ifnecessary,consultarepresentativeofDell™Inc.oranexperiencedradio/televisiontechnicianforadditionalsuggestions.
The following information is provided on the device or devices covered in this document in compliance with the FCC regulations:
l Productname:Dell™2407WFP-HC
l Modelnumber:Dell™2407WFPb
l Company name:
Dell Inc.
Worldwide Regulatory Compliance & Environmental Affairs
One Dell Way
Round Rock, Texas 78682 USA
512-338-4400
CAUTION: Safety Instructions
Read and follow these instructions when connecting and using your computer monitor:
l Tohelpavoiddamagingyourcomputer,besurethatthevoltageselectionswitchonthepowersupplyforthecomputerissettomatchthealternating
current (AC) power available at your location:
¡ 115 volts (V)/60 hertz (Hz) in most of North and South America and some Far Eastern countries such as Japan, South Korea (also 220 volts (V)/60
hertz (Hz)), and Taiwan.
¡ 230 volts (V)/50 hertz (Hz) in most of Europe, the Middle East, and the Far East.
l Always be sure that your monitor is electrically rated to operate with the AC power available in your location.
l Do not store or use the monitor in locations that are exposed to heat, direct sunlight, or extreme cold.
l Avoid moving the monitor between locations with large temperature differences.
l Do not subject the monitor to severe vibration or high impact conditions. For example, do not place the monitor inside a car trunk.
l Do not store or use the monitor in locations exposed to high humidity or dusty environment.
l Do not allow water or other liquids to spill on or into the monitor.
l Keep flat panel monitor in room temperature conditions. Excessive cold or hot conditions can have an adverse effect on the liquid crystal of the display.
l Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.
NOTICE: TheFCCregulationsprovidethatchangesormodificationsnotexpresslyapprovedbyDell™Inc.couldvoidyourauthoritytooperatethis
equipment.
NOTE: For Further regulatory information, see your Product Information Guide.
CAUTION: Use of controls, adjustments, or procedures other than those specified in this documentation may result in exposure to shock, electrical
hazards, and/or mechanical hazards.
NOTE: This monitor does not need or have a voltage selection switch for setting the AC voltage input. It will automatically accept any AC input voltage
according to the ranges defined in the "Electrical Specifications" section in the User's Guide.