Dell 2407WFP-HC Car Video System User Manual


  Open as PDF
of 49
 
OSD Warning Messages


Back
Mode
When PIP/PBP activated
PIP/PBP Source
PIP Position
PIP Size
PIP/PBP Contrast
PIP/PBP Hue/Tint
PIP/PBP Saturation
Exit Menu
 or
PIP/PBP submenu when PIP/PBP ON(mainsourceisVGA/DVI-Dinput)
PIP/PBP submenu when PIP/PBP ON
 or
NOTE:
When using DVI source, the contrast adjustment is not available.
Push to go back to the main menu.
There is two modes: PIP (Picture in Picture) and PBP (Picture By Picture)
Use and tobrowseand to select "Off", "PIP" or "PBP".
When PIP/PBP is activated, select "Swap" to
exchange the input source for the main screen and PIP/PBP window.
Select an input signal for PIP/PBP. (VGA/DVI/S-Video/Composite/Component)
Use and tobrowseand to select.
Select PIP window position.
Use and tobrowseand to select.
Select PIP window size.
Use and tobrowseand to select.
Adjust the contrast level of the picture in PIP/PBP Mode.
reduce the contrast
increases the contrast
This function shifts the color of PIP/PBP image to green or purple. This is used to adjust for desired flesh tone color.
shifts image color towards green
shifts image color towards purple
Adjust the color saturation of PIP/PBP image.
makes the image look more monochrome
makes the image look more colorful
Push to exit the OSD main menu.
YourmonitorwillpromptyoutoachievethebestperformancewhenyouselectPBP.Youmayseethefollowingmessagesundercertaincombinationsofinput
sources in PBP mode.
 previous next