Dell G2410 Car Video System User Manual


  Open as PDF
of 34
 
Back to Contents Page
Setting Up the Monitor
Dell™G2210/G2410FlatPanelMonitorUser'sGuide
Attaching the Stand
Connecting the Monitor
Organizing the Cables
Attaching the Soundbar (Optional)
Removing the Stand
Wall Mounting (Optional)
Attaching the Stand
Remove the monitor cover and place the monitor on it.
1. Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.
2. Lowerthestandsothatthemonitormountingareasnapsontothestand.
Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer.Donotconnectbothcablesonthesamecomputer. Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the White DVI Cable
NOTE: The stand is detached from monitor when it is shipped from the factory.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.
 previous next