Filter
Top Products
English
|
41
Installation
Locking the Backpanel to the unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1 Refer to the Removing the Backpanel function of
the section on 'Theft Deterrent Panel' (page 17)
and remove the Backpanel.
2 Insert the panel lock screws into the holes at the
sides of the panel.
Accessory4
3 Reattach the Backpanel.
• Never insert the panel lock screws in any other screw
holes than the one specified. If you insert them in
another hole, it will contract and may cause damage to
the mechanical parts inside the unit.
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
Installation
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
• To attach this unit, make sure the front of the control
panel faces you and fit it into the mounting sleeve by
pressing the four corners of the hard rubber frame at the
same time.
Do not apply strong pressure to other sections than the
corners; otherwise troubles such as the impossibility of
opening or closing the panel may result.
• The hollow at the center of the rubber frame is designed
to make it easier to remove discs.
If you do not want the hollow to be visible, mount the
rubber frame in the opposite direction (with the flat side
at the top instead of the bottom).