Eclipse - Fujitsu Ten CD3000 Car Video System User Manual


 
How to operate the tuner
23
V
How to operate the tuner
ATTENTION
If stations have been stored in memory,
pressing the stored button from [1] to [6] will
directly select a station. (Refer to "Manually
setting stations into memory" on page 24)
Tuning to a station
First, press the [FM AM] button to start tuner
operation.
There are automatic and manual methods for
setting stations in memory. The receiver will
accept up to 24 stations in memory: 6 in AM 18 in
FM (6 each for FM1, FM2 and FM3.) (Initial
setting)
Radio bands will switch from FM1
FM2 FM3 AM in order each time
the button is pressed.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
[]
button:
Starts searching toward higher
frequencies.
[] button:
Starts searching toward lower
frequencies.
ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals’ strength.
Other factors affecting reception include
interference from natural obstacles, sign posts,
etc.
When an optional HD Radio tuner unit is
connected, digital broadcasts have reception
priority. (U.S.A. only)
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.
1
Press the [FM AM] button for less
than one second to switch to the
desired FM, AM bands.
2
Turn the [SEL] button to the left or
right to tune to a station.
3
Press the [ ] or [ ] button to
start the automatic station search.
IV