Filter
Top Products
How to operate the tuner with an optional SIRIUS satellite radio tuner connected (U.S.A. only)
55
XVI
Direct channel selection
The channel can be selected by inputting the
channel directly.
The mode will change to direct
channel selection mode.
[1] button ..........Hundreds
[2] button ..........Tens
[3] button ..........Units
Each time the buttons are pressed, the
numerals change in the following
order.
0 ➔ 1 ➔ 2 ➔ 3 ➔ 4 ➔ 5 ➔ 6 ➔ 7 ➔ 8
➔ 9
Pressing the button [6] clears the
numeral at the previous digit.
Starts reception.
Manually setting channels into
memory
This section covers the setting of channels in
memory under the numbered buttons.
The tuned channel is now memorized
and set in the selected button. Repeat
the procedure to set additional
manually tuned channels in memory,
in turn, for buttons [1] to [6]. These
buttons are called the preset buttons.
ATTENTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
equipment), all channels in memory will be
lost. In such a case, set channels in memory
again.
Preset channel scan
This function enables reception of all the
channels in the preset buttons for five seconds
each.
[P SCAN] will appear at the display,
and channels stored under preset
buttons [1] to [6] will be played for five
seconds each.
The equipment will stay tuned to the
desired channel.
Switching displays when using
the SIRIUS satellite radio
Each time the button is pressed the
display item changes in the following
order:
channel name ➔ category name ➔
title ➔ artist ➔ SIRIUS unit ID.
ATTENTION
• The maximum number of characters that
can be displayed for each item is as follows:
Title: 38 characters
Artist: 38 characters
Channel: 20 characters
Category: 16 characters
• If there is no name, NO_ DATA will appear.
1
Press and hold the [SEL] button for
more than two seconds.
2
Press the buttons [1], [2] and [3] to
select the channel number to be
input.
3
Press the button [5].
1
Turn the [SEL] button to the right
or left to tune to the channel to be
entered in memory.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
1
Press the [SEL] button for less
than two seconds.
2
To stop the preset scan mode at a
desired channel, press the [SEL]
button again.
1
Press the [DISP] button for more
than one second.