Filter
Top Products
92
Operation
ATTENTION
• If stations have been stored in
memory, pressing a button from [1]
to [6] will directly select a station.
(Refer to "Manually setting
stations into memory" on page 93)
First, press the [FM AM] button to start tuner
operation.
There are automatic and manual methods for
setting stations in memory. The receiver will
accept up to 30 stations in memory: 6 in AM
(MW), 6 in LW and 18 in FM (6 each for FM1,
FM2 and FM3.) (Initial setting)
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM (MW) ➔ LW in
order each time the button is
pressed.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
[]
button:
Starts searching toward higher
frequencies.
[] button:
Starts searching toward lower
frequencies.
ATTENTION
At times, it may be difficult to maintain
optimum reception because the antenna
affixed to your vehicle is in motion
constantly (relative to the broadcast
antenna), encountering continuous variation
in the received radio signals’ strength. Other
factors affecting reception include
interference from natural obstacles, sign
posts, etc.
You can switch the mode to
desired one.
The automatic preset mode starts.
The [ASM ON] indicator on the
screen flashes, and stations are
automatically entered in memory
under buttons [1] to [6].
These buttons are called preset
buttons.
Tuning to a station
1
Press the [FM AM] button for less
than one second to switch to the
desired FM, AM (MW) and LW
bands.
2
Turn the [SEL] button to the left or
right to tune to a station.
3
Press the [ ] or [ ] button to
start the automatic station
Entering stations into
memory automatically
(The automatic preset mode:
ASM)
1
Press the [FM AM] button for less
than one second.
2
Press the [SEL] button for more
than two seconds until a beep is
heard.