Filter
Top Products
How to operate the tuner
93
ATTENTION
• Pressing the preset buttons ([1] to
[6]) allows you to make one-touch
station selections. The frequency
of the selected station is indicated
on.
• When a new station is set in
memory, the station previously set
in memory will be deleted.
• If there are fewer than six
receivable stations, the stations
set in the remaining buttons will be
retained.
This section covers the setting of stations in
memory under the numbered buttons.
You can switch the mode to desired
one.
The tuned station is now
memorized and set in the button
selected. Repeat the procedure to
set additional manually tuned
stations in memory, in turn, for
buttons [1] to [6]. These buttons
are called the preset buttons.
This function enables reception of all the
stations in the preset buttons for five seconds
each.
[P SCAN] will appear on the
display, and stations stored under
preset buttons [1] through [6] will
be played for five seconds each.
The receiver will stay tuned to the
desired station.
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in the memory
again.
Manually setting stations
into memory
1
Press the [FM AM] button for less
than one second.
2
Turn the [SEL] button to the right
or left to tune to the station to be
entered in memory.
3
Select any button, from [1] to [6],
and press it for more than two
seconds.
CAUTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or for removing the
receiver), all stations in memory will be lost.
In such a case, set stations in memory
again.
Preset station scan
1
Press the [SEL] button for less
than two seconds.
2
To stop the preset scan mode at a
desired station, press the [SEL]
button again.
VI