Filter
Top Products
MPA 152 Amplier • Installation
Installation, cont’d
2-6
Under-furniture mounting
The MPA 152 amplifer can be mounted under furniture using
the optional MBU 123 mounting kit (PN 70-212-01):
1. Attach the mounting brackets to the MPA 152 with the
provided machine screws as shown in the gure below.
2. Hold the amplier with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
3. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked locations.
4. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw head protrudes.
5. Align the amplier so that the screw heads pass through
the slots in the brackets and the unit is resting rmly
against the bottom surface of the furniture.
Figure 2-3 — Under furniture mounting
6. Slide the unit slightly forward or back. Tighten all four
screws to secure it in place.