Filter
Top Products
10
10
PROGRAMMING SOURCES
Table 1 – Remote Control Codes
*
Do not reprogram the DVD Source Selector unless you are replacing
the DVD player included in the CP 60 system with another product.
If you are unable to locate a code set that correctly operates your
source device, it will not be possible to use the RCP 6 remote to control
that device. However, you may still connect the source to the AVR 247
and operate it using the device’s original remote control.
Most of the button labels on the remote describe the button’s function
when used to control the AVR 247 (gray labels) or DVD 38 (blue
labels). However, the button may perform a very different function when
used to control another device. Refer to the Remote Control Function
List, Table A1 in the Appendix, for a list of each button’s
functions with the various product types.
If you wish, you may program macros, which are preprogrammed
code sequences that execute many code commands with a single
button press. You may also program “punch-through” codes, which
allow the remote to operate the volume, channel or transport controls
of another device without having to switch the remote’s device mode.
See page 12 for instructions on these advanced programming
functions.
NOTE: The RCP 6 remote is preprogrammed to operate the
transport controls of the DVD 38 when the AVR or VID2 or
VID3 device
is selected.
You may change this punch-through
programming at any time, as explained in the Advanced
Functions section.
Source Input Product Type Remote Control Code
(circle one)
Video 1 VCR, PVR
Video 2 Cable, Satellite
Video 3 TV
Video 4 TV
HDMI 1 DVD, VCR/PVR,
Cable, Satellite
HDMI 2 DVD, VCR/PVR,
Cable, Satellite
DVD
*
DVD
CD CD, CD-R
Tape Cassette
RCP 6 om.qxd 3/15/07 11:19 AM Page 10