Filter
Top Products
hp pavilion f50/f70 LCD Monitor
Setting Up the Monitor
14 English
Connecting the cables to the f70 monitor
Look at the following diagram and follow the steps listed below to
connect the cables to the f70 17-inch LCD monitor.
CAUTION: This monitor is equipped with an auto-sensing
power supply for voltage ranges 100—240 V~,
50/60 Hz. Use the monitor with the supplied DC
adapter only.
To connect the cables to the f70 monitor:
1 Make sure the computer is turned off.
2 Plug the video cable into the correct video connector (VGA or
DVI-D) on the back of the monitor and into the corresponding video
connector on the computer. Secure the cable by tightening the
thumbscrews.
VGA cable → VGA connector
DVI-D cable
→ DVI-D connector
Video cable
(VGA)
Microphone
(pink)
Audio out
(green)
OR
DVI
Audio
cable
Volume
control
DC adapter
with attached DC cable
Power
source
DC In
cable
VGA
Video
connectors
Power
cord
X