Filter
Top Products
Removing the Computer from the Stand
CAUTION: Before beginning to disassemble the computer, be sure the computer is turned off and all
cables are disconnected.
1. Turn off power to the computer and unplug the power cable from the electrical wall outlet.
2. On the USDT assembled integrated work center, remove the port cover by pulling back the
retention lever inside the bottom port cover opening then slide the cover up and off the computer.
3. Disconnect all the cables from the rear of the computer.
4. Remove the two screws from the top of the computer mounting bracket (1) and slide the computer
up and off the stand (2).
Figure 3-21 Removing the Computer from the Stand (USDT Computer Shown)
ENWW Removing the Computer from the Stand 17