Filter
Top Products
13
CONNECTION AND SETUP
If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets
on the hi-fi system, using an appropriate cable (see “Connection example”).
The electric digital output is intended for the connection of a Dolby Digital system (see “Connection
example”).
TV AND VCR CONNECTION
AUDIO CONNECTION
ELECTRICAL DIGITAL OUTPUT
INSERTING BATTERIES INTO THE REMOTE CONTROL
Connect the cable receiver (HDMI or alternatively TV Scart socket) and the TV set using an HDMI or
Scart cable (see “Connection example”). If your TV is stereo, you can receive the sound in stereo via
the HDMI or Scart connection.
For system reasons, the same video signals are to be found at the TV Scart socket as at the video cinch
output.
Use a Scart cable to connect the cable receiver (TV Scart socket) to the video recorder/PVR.
Remove the cover on the rear of the remote control. Insert the two batteries supplied into the remote
control. Ensure correct polarity of the batteries; the + and – markings as indicated inside the battery
compartment. Slide the cover back onto the housing until it locks in place.
Connecting a video recorder/PVR to the TV Scart socket allows you only to
record. It does not allow you to play back on the TV set via the receiver. If you
are recording via an external video recorder/PVR, remember not to operate the
receiver during recording, otherwise all the on-screen displays will appear on your
recording.