55
USING THE FRONT PANEL/SERVICE
If you have misplaced your remote control, or if the batteries are fl at, you can still operate your receiver
from the front panel.
BACKUP OPERATION
There are three buttons on the front of the receiver:
Power switch
1)
(On/Off):
The power switch allows you to switch the receiver on (operation) and off again. You have no facility to
switch the receiver into stand-by mode, since no stand-by switch is provided on the front or rear of the unit.
▼ button:
The channel down button switches to the next channel down in the currently selected channel list.
▲ button:
The channel up button switches to the next channel up in the currently selected channel list.
Because there are no numbered buttons, no password/PIN-protected functions
can be displayed.
If, despite studying this operating manual, you still have questions about getting started with the
unit or using it correctly, or if unexpected problems occur, please contact your specialist dealer.
The Kathrein customer hotline is also at your disposal.
Tel: 0900/1122240 *
* (0.49 EUR per minute on Deutsche Telekom AG land lines, calls from mobile phones may cost more)
SERVICE
1
) The unit is not fully disconnected from the mains (see the sections “Safety Instructions - Important Instructions” and “Periods of
extended absence, thunderstorms, mains socket accessibility”)