Filter
Top Products
54
CONNECTION/INSTALLATION
❏Supplied accessories for installation
1 Wiring harness x 1
2 Extension wire x 1
3 Flat head screws (M5 x 7 mm) x 6
4 Round head screws (M5 x 6 mm) x 6
5 Steering Remote cable x 1
6 Microphone x 1
7 Fixture for HDMI/MHL connector x 1
8 Screws for fixture (M2.6 x 6 mm) x 1
❏Installation procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the
·
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7 Reconnect the · battery.
8 Press the reset button.
9 Configure <Initial Setup>. (Page4)
Installing the unit
❏Installing the unit using the mounting
bracket removed from the car
Car Bracket
3 or 4
3 or 4
• Select the appropriate type of screw for the
mounting bracket: flat head (3) or round head
(4).