Kenwood DDX8034BTM Car Satellite TV System User Manual


 
90 DDX8034BT/DDX8034BTM
Help? Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
! • Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
<Speaker Setup> (page 73)
The DSP Select is Bypass.
<DSP Bypass Control> (page 72)
The Dual zone function is enabled.
<Zone Control> (page 56)
The unit is set to STANDBY source.
! • Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
<Zone Control> (page 56)
! Cannot play audio files.
"CD Read" of <Disc Setup> (page 78) is set to
"2".
! Cannot Folder select.
The Random play function is enabled.
! Cannot perform Repeat play.
The PBC function is enabled.
! • Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
<Zone Control> (page 56)
The DSP Select is Bypass.
<DSP Bypass Control> (page 72)
The equalizer is set to "iPod".
<Equalizer Control> (page 55)
The unit is set to STANDBY source.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone doesn’t sound.
The preout jack is being used.
The Touch Sensor Tone can’t be output from
the preout jack.
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
? The specified disc does not play, but another
one plays instead.
The specified CD is quite dirty.
Clean the CD.
The disc is severely scratched.
Try another disc instead.
Audio file source
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
The recording condition is bad.
Record the media again or use another
media.