Filter
Top Products
Solutions to Common Problems
15
Appendix E Skew Module
The Cobra R1300A / R1300S2 receivers have an optional skew
compensation module that can be installed or removed.
To install the skew compensation module:
1. Remove top cover.
2. Remove the 3 jumpers from J16 pins 1-2, 4-5, 7-8.
3. Insert the Skew assembly onto the PCB using 11 pin headers J16 and J17.
4. The correct orientation of the skew board is to place the side with the logo
into header J17.
5. Reassemble unit.
Removal is the opposite of the above. Ensure 3 jumpers are installed in
locations shown in Figure 6:
Figure 6: Skew Module