Kramer Electronics Cobra R1300A Car Video System User Manual


 
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Setup and Installation
6
4.4 Connections on the single-port VGA S2
The Single-Port Cobra CAT 5 Video System series supports RS-232, video
and stereo audio signals over CAT 5 cable. Serial signals are 3 wire RS232
(Tx, Rx, ground) and fixed at 9600 baud. Full 9 pin modem signals are not
supported. Note when using the Cobra 2/S2 series with a Cobra CAT 5 DA
or CAT 5 matrix switch, the serial is transmit only. There are no
configuration changes required to the units. The serial application in use
should be changed to transmit only. Audio is full stereo, line level. One or
two separate channels of mono audio may also be used. See the Figures
below for cabling connections.
Figure 3: Transmitter Connections
Figure 4: Cobra R1300S2 Universal Receiver Connections