Filter
Top Products
VA-8xl - Operating the VA-8xl 9
3. Press the UP or DOWN button once to increase or decrease, as
appropriate, in increments of 0.5dB. Press and hold the UP or DOWN
button, to increase or decrease the decibel level by a significant amount.
4. Press the LEFT LEVEL or the RIGHT LEVEL button to set the level.
The bright LEFT and/or RIGHT LED display becomes dim again, preventing
unintentionally altering the settings.
5.2 Storing and Recalling Setups
You can store/recall up to 15 settings in the non-volatile memory, via the front
panel buttons, or remotely via RS-232 or RS-485.
A setting refers to the gain/attenuation level of the selected channel that appears
in the dimmed LED displays, and each setting includes all 8 channels.
To store a setting, via the front panel buttons:
1. When the LED displays are dimmed, press the DOWN button.
The abbreviation “StO” (store) appears in the LEFT LED display.
2. Choose a setup number (between 1 to 8), by pressing the appropriate
CHANNEL SELECTOR button.
The abbreviation “StO” (store) appears in the LEFT LED display and the
setup number appears in the RIGHT LED display.
3. Press the same CHANNEL SELECTOR button again.
The memory stores the chosen setup number. As confirmation, for a few
seconds, “YES” appears in the LEFT LED display and the setup number
appears in the RIGHT LED display.
Note:
Saving a setup to an previously allocated setup number, overwrites the
previous setup
To cancel, press the LEFT or RIGHT button