Filter
Top Products
23
206-4118
Teach Master TV Setup to Target TV
After Learning is complete, remove the MPI cable from the
Master TV, and connect it to the Target TV into which you
wish to copy the Master TV Setup. With “THE CLONE HAS
CONTROL OF TV” message displayed, press 2 or use
either Channel key to select the TEACH TO TV option, and
press ON/OFF, POWER, or ENTER. Select the LT2002
memory in which the new setup is located. Press ON/OFF
to transfer the new setup and other information to the new
TV. Teaching usually takes 2 to 3 minutes. After the
“TEACHING COMPLETE” message is displayed, press any
key to return to the Clone Selection Menu; then press ON/
OFF, POWER, or ENTER. When finished, detach the MPI
cable from the target, newly-cloned TV.
Disconnect TV Power for 15 Seconds
Unplug the AC power cord of the newly-cloned TV from the
power outlet for about 15 seconds to activate the newly-
copied setup.
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV
Target TV
Clone Programmer
QuickSet II Programmer
LT2002
®
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA
tIFBSUCFBUQPXFSPO
communications ok
tTMPX QPXFSPO
no communications
tHSFFO CBUUFSZPL
tSFE CBUUFSZMPX
#MJOLQBUUFSO
$PMPS
Reset
Status
*OEJDBUPS
$POOFDUDBCMFUP
57.1*+BDLBOE
GPMMPXPOTDSFFO
instructions
MPI
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK= XX:XX
TV CLOCK= XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
This display will appear
after Teaching is complete.
This display will appear
during Teaching function.
Teaching the Master Setup to Another TV
Connections for the LT2002 to Teach Another TV the Master Setup
LT2002 Cloning Connections / Teaching Setup
► If an analog channel is not available, tune the TV to an Aux source,
such as AV-1, for cloning purposes.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
-TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
-TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
This menu should appear
after any key is pressed
on the Installer Remote.
TEACHING IN PROGRESS,
PLEASE WAIT
TEACHING COMPLETE