LG Electronics 32LT770H Car Satellite TV System User Manual


 
51
206-4214
2. Follow the on-screen instructions to complete the appropriate
network conguration. Use the Installer Remote navigate elds
and make entries, etc.
Once you have specied conguration details as necessary,
the TV will attempt to connect to the network and you will
see a progress screen that indicates status as each network
element is conrmed (see example at right). If the network is
connected successfully, a “Wireless network is connected”
message will be displayed at the top of the screen and the
network conguration data will be displayed in the lower half
of the screen.
3. Select Complete (if not already selected), and then press OK
on the Installer Remote to exit the Network Connection wizard
and return to the IP Environment Menu.
Note: If the network connection is not successful, the progress
screen will identify the network element in which the connection
failed. Check your cabling and/or, if necessary, press on the
Installer Remote to return to previous screens to verify the
conguration data.
IP Environment Setup (Cont.)
Network Connection
Wireless network is connected.
Complete
Wireless : NetworkName
TV Gateway DNS Internet
MAC Address : AA:BB:CC:DD:EE:23 Gateway : 10.10.10.10
IP Address : 10.2.3.4 DNS Server : 10.5.6.7
Subnet Mask : 255.255.255.0
Network Status
This option enables you to check the status of the network connection.
Note: If both wired and wireless network connections were congured in a previous session
in the IP Environment Menu, and a LAN cable is connected/detected between the TV and the
network, the Network Status operation rst will attempt to connect to the network via the wired
connection. If a wired connection is not detected, the Network Status then will attempt a wireless
connection, if one has been congured. On the other hand, if, during the current session, you
congured rst a wired and then a wireless network connection, the Network Status operation
will rst attempt to connect to the network via the wireless connection (i.e., the last connection
congured).
1. With the IP Environment Menu on display, use the arrow keys on the Installer Remote to
select Network Status. Then, press OK.
(Continued from previous page)
Note: Make sure you have the network security password/PIN available if you are attempting to
connect to a secured network.
Note: (AP List and Enter the SSID options only) As with a wired connection, a second Network
Connection window will enable you to specify the IP and DNS conguration for this network
connection. Auto (DHCP) tabs will be selected by default. If a DHCP server is congured and a
static conguration is not required, you can simply select OK (on the screen) and then press OK
on the Installer Remote. The DHCP server will assign an IP address and DNS server to the TV
for this network connection once the TV successfully connects to the network. Otherwise, use
the arrow keys to select the Static tab(s), and specify the static conguration data for both the IP
and DNS modes. When all elds are completed, select OK (on the screen) and press OK on the
Installer Remote.
(Continued on next page)