Filter
Top Products
56
206-4214
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 001). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Master TV Setup and TV cloning procedures are
complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
INTERFACE port on the TV’s rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio
connectors, as applicable, for the cable bundle.
Remote Jack Pack / TV Connections & Setup
RGB IN (PC)
ANTENNA/
CABLE IN
TV-LINK CFG
AUDIO IN
(RGB/DVI)
SPEAKER
OUT(8Ω)
SERVICE ONLY
RESET
UPDATE
RJP
INTERFACE
GAME CONTROL
/MPI
RS-232C
(SERVICE & EXT POWER)
VIDEO
L/MONO-AUDIO-R
AV IN
L R
2
/ DVI IN
1
(ARC)
LAN
OPTICAL
DIGITAL
..........
..........
AUX LAN
HDMI/DVI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP INTERFACE
Connect RJ-45 Control cable
from RJP cable bundle.
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
093 RJP AVAILABLE 001
RGB IN (PC)
Connect RGB connector
from RJP cable bundle
(legacy RJP only).