Marantz NR1605 Car Speaker User Manual


 
o
Power does not turn on / Power is turned off
Symptom Cause / Solution Page
Power does not turn on.
0
Check whether the power plug is correctly inserted into the power outlet. 54
Power automatically turns
off.
0
The sleep timer is set. Turn on the power again. 129
0
“Auto Standby” is set. “Auto Standby” is triggered when there is no operation for a set amount of time. To
disable “Auto Standby”, set “Auto Standby” on the menu to “Off”.
202
Power turns off and the
power indicator flashes in
red approx. every 2
seconds.
0
The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off,
wait about an hour until this unit cools down sufficiently, and then turn the power on again.
257
0
Please re-install this unit in a place having good ventilation.
Power turns off and the
power indicator flashes in
red approx. every 0.5
seconds.
0
Check the speaker connections. The protection circuit may have been activated because speaker cable
core wires came in contact with each other or a core wire was disconnected from the connector and
came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action
such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire.
28
0
Turn down the volume and turn on the power again.
56
0
This unit’s amplifier circuit has failed. Unplug the power cord and contact our customer service center.
Power does not turn off
even when the power
button is pressed, and the
display shows “ZONE2
On”.
0
The power supply of ZONE2 is turned to ON. To turn off the power supply of this unit (standby), press the
ZONE2 ON/OFF on the main unit, or press the POWER X
button after pressing the ZONE2 button on the
remote control unit to turn off the power supply of ZONE2.
Contents Connections Playback Settings Tips Appendix
216
Front panel Display Rear panel Remote Index