Marantz PM-11S3 Car Amplifier User Manual


 
12
ENGLISH
n High frequency range
The high frequency range can be trimmed in 2 dB steps across
a –8 – +8 dB range. When the unit is shipped from the factory,
the level is set to 0.0 dB. Before making this adjustment, press
TONE on the unit or the remote control to set the tone control
to on.
1
Press MENU.
The unit enters the level adjustment
mode.
2
Press ENTER twice.
The adjustment mode selects the
high frequency range.
3
Press df to adjust the level.
•If not operated for 15 seconds, the current setting is saved
and the display returns to normal.
NOTE
Before making the adjustment for level and tone, press MODE/
AMP to set its control mode to amplifier.
Starting playback
Adjusting the levels
n Left and right channel balance
The volume level of the left and right channels can be trimmed
in 0.5 dB steps across a 0.0 – 9.0 dB range. When the unit is
shipped from the factory, the volume level is set to 0.0 dB
(maximum).
1
Press MENU.
The unit enters the level adjustment
mode.
•The left channel level value flashes.
2
Press df to adjust the left channel level.
3
Press 1.
The adjustment mode selects the right channel.
•The tight channel level value flashes.
4
Press df to adjust the right channel level.
5
Press MENU.
The unit exits the adjustment mode.
•If you have connected a “SLAVE” device using the F.C.B.S.
connection (vpage14), proceed to the slave setting.
Adjusting the tone
n Low frequency range
The low frequency range can be trimmed in 2 dB steps across
a –8 – +8 dB range. When the unit is shipped from the factory,
the level is set to 0.0 dB. Before making this adjustment, press
TONE on the unit or the remote control to set the tone control
to on.
1
Press MENU.
The unit enters the level adjustment
mode.
2
Press ENTER.
The adjustment mode selects the
low frequency range.
3
Press df to adjust the level.
•If not operated for 15 seconds, the current setting is saved
and the display returns to normal.
1.PM-11S3U_ENG_0521.indd 12 2012/05/21 19:03:32