Filter
Top Products
English-36
To RS-232C
connector IN
To CAT5 RGB5
connector OUT
To CAT5 RGB5
connector OUT
RS-232C cable
RS-232C cable
USB cable
RS-232C cable
CAT5 cable CAT5 cable
PC
PC
Type A Type B
Monitor
Monitor
Monitor
Monitor
To RS-232C
connector IN
To RS-232C
connector IN
To CAT5
connector OUT
CAT5 Tx BOX
(accessory)
To RS-232C
connector OUT
To CAT5 RGB5
connector IN
To CAT5 RGB5
connector IN
To RS-232C
connector OUT
* This connection isn’t necessary
when the USB COM port is used.
U-11 Remote control
Carry out as necessary
RS-232C/RS-485 Remote control
By connecting multiple LCD monitors and a computer using RS-232C cables (commercially available) or CAT5 cables (commercially
available), you can control the monitors from the computer via the supplied CAT5 Tx BOX for the following operations:
• Power ON or OFF
• Switching between input signals
• Volume control and mute
• Auto setup
Connection
Connection by RS-232C (For RS-232C cable (commercially available), the reverse type cable should be used.)
Connection by CAT5 RS-485 (For CAT5 cable (commercially available), the straight type cable should be used)
• Before making connections, turn off the personal computer and the monitors.
• Start the personal computer fi rst, and then turn on the monitors. (Otherwise, the com port may be unusable.)
NOTE:
For connection with a 25-pin serial port connector on the computer, a conversion adapter (commercially available) is required.
1) Interface
PROTOCOL RS-232C/RS-485 (CAT5)
BAUD RATE 9600 [bps]
DATA LENGTH 8 [bit]
PARITY BIT NONE
STOP BIT 1 [bit]
FLOW CONTROL NONE
This LCD monitor uses RXD, TXD and GND lines for RS-232C control.
CAT5 Tx BOX uses RXD, TXD, DTR, and GND lines for RS-485 control with RS-232C connector.
Because the communication system of RS-485 is a half duplex, CAT5 Tx BOX uses RXD, TXD, and RTS lines for RS-485 control
with USB connector.
Downloaded From TV-Manual.com Manuals