Onkyo CR-505DA Car Stereo System User Manual


 
7
Before Using the CR-505DAB
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AAA/
R03) in accordance with the polarity dia-
gram inside the battery compartment.
3
Close the battery compartment.
Notes:
The supplied batteries should last for about six months,
although this will vary with usage.
If the remote controller doesnt work reliably, try replac-
ing both batteries.
Dont mix new and old batteries, or different types of bat-
teries.
If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
Drained batteries should be removed as soon as possible
to prevent possible leakage and corrosion.
To use the remote controller, point it at the CR-505DABs
remote control sensor, as shown below.
Notes:
The remote controller may not work reliably if the CR-
505DAB is subjected to bright light, such as direct sunlight
or inverter type uorescent lights. Keep this in mind when
installing the CR-505DAB.
If another remote controller of the same type is used in
the same room, or the CR-505DAB is installed close to
equipment that uses infrared rays, the remote controller
may not work reliably.
Dont put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvertently,
thereby draining the batteries.
The remote controller may not work reliably if the CR-
505DAB is installed in a rack behind colored glass doors.
Keep this in mind when installing the CR-505DAB.
The remote controller will not work if theres an obstacle
between it and the CR-505DABs remote control sensor.
Installing the Remote Controller
Batteries
Using the Remote Controller
CR-505DAB
5 m
R
C
-
5
8
1
S
Remote control
sensor