Filter
Top Products
38
39
Main Menu (continued)
Note on FULL/PART selection
This function is designed to enable comparison of identical formats input to the same input terminal. Input of different formats via dif-
ferent input lines may distort the sub-window (left side, still image) or make part of the image disappear from view. However, input of
an identical format signal to the input terminal during still image acquisition will display correctly.
WFM/VECTOR
The WFM/VECTOR function enables display of the waveform and vector display. Use [DISPLAY SETUP] in [MAIN MENU] (main
menu) to select WFM and VECTOR display.(→page 46)
Press the <FUNCTION1> to <FUNCTION5> (→page 12) button to which the WFM/VECTOR function has been assigned to switch
displays in the following order.
[WFM/VECTOR OFF] → [WFM Y ON] → [WFM R ON] → [WFM G ON] → [WFM B ON] → [VECTOR×1/×2S/×2/×4/×8]
• To use the WFM/VECTOR function, it must be assigned to one of the <FUNCTION1> to <FUNCTION5> buttons.
“WFM” signals are displayed in the following order: Y, R, G, B.
Normal screen
Press the <FUNCTION> button to
which the WFM/VECTOR function
has been assigned.
WFM display
(Y→R→G→B)
VECTOR display
*
12
Press the same
button again
VECTOR
(vector display)
WFM (waveform
display)
These examples show 16:9 aspect ratio images.
*
12
Displayed only for SDI signal input.
• The scale display is as shown below.
100 %
109 %
A dotted line
indicates for
each 10 %
increase.
4 %
50 %
0 %
I axis
Q axis
BLUE
The frame is approx.
2.5 degrees and
approx. 2.5%.
MAGENTARED
YELLOW
GREEN
CYAN
The vertical lines in the frame are color coded to simplify
identification.
Press the same button again