Filter
Top Products
18
DISPDISPDISPDISP
SiriusXM Satellite Radio Control (continued)
System control mode selection
Function settings
[BAND]
[DISP]
[SEL]
[TUNE/SEEK }] (d)
[TUNE/SEEK {] (s)
Satellite Radio indicator
Signal strength indicator
SiriusXM radio display
Press and hold [SEL] for more than 2 seconds to open SXM function setting screen.
Turn [SEL] to open alarm time setting screen.
Turn [SEL] back to SXM function setting screen.
SiriusXM function setting mode
Note: See below “Function settings” for its inside setting.
Alarm time setting mode
Note:
Refer page 20 and follow its steps from 2 to 6 to set alarm time if needed.
Channel direct selection mode
A channel is directly selected with the channel
number entry.
1
Press and hold [SEL] for more than 2 sec-
onds to open SXM function setting screen.
2
The radio automatically enters the SXM
direct channel selection mode after 2
seconds when entering the SXM function
setting screen.
Channel direct
selection mode
3
Press [d] or [s] to select a number.
4
Press [BAND] to enter the next digit.
5
If necessary, repeat steps 3 and 4 to enter
more digits of the channel number.
6
Press [SEL] when done entering the chan-
nel number digits and the radio tunes to
the desired channel.
Notes:
¡ ”CH UNAVL” is displayed when the requested
channel is not valid. Visit www.siriusxm.com to
see the list of channels available.
¡ ”CH UNSUB” is displayed when the requested
channel is not part of the current subscription
package. Visit www.siriusxm.com for information
on subscription packages.