Filter
Top Products
30
Preparation Installation hardware
No. Item Diagram Q’ty
q
Mounting Collar*
1
w
Plain Washer (5 mm ø)
2
e
Spring Washer (5 mm ø)
2
r
Hex. Nut (5 mm ø)
2
t
Rear Support Strap
1
y
Hex. Bolt
(5 mm ø × 25 mm)
1
u
Toothed Lock Washer
(5 mm ø)
1
i
Removal Tool
(U-shaped)
2
Warning
If your vehicle is equipped with air bag and/or
anti-theft systems, specific procedures may be
required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic
component, contact your vehicle dealer or manu-
facturer to determine the required procedure and
strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VE-
HICLE AND PERSONAL INJURY OR DEATH.
¡ Disconnect the cable from the negative @ battery
terminal (see caution below).
¡ Remove Mounting Collar q from the main unit
temporarily, which are already mounted at ship-
ment.*
¡ Unit should be installed in a horizontal position
with the front end up at a convenient angle, but
not more than 30˚.
Caution
Various settings that have been stored in the
memory in other on-board equipment (vehicle
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or
to back up the settings before disconnecting the
terminals.
After completing installation of the main unit, set
the equipment again according to the record.
Dashboard installation
Installation Opening
This unit can be installed in any dashboard having
an opening as shown below. The dashboard should
be 4.75 mm {3/16”} – 5.56 mm {7/32”} thick in
order to be able to support the unit.
182 mm
{7-
5
/32"}
53 mm
{2-
3
/32"}
Mounting bolt
(5 mm ø)
q Mounting Collar
Rear support bracket
(provided on the vehicle)
Rubber cushion (option)
(a) Using the rear support strap t
(b) Using the rubber cushion (option)
Installation Guide (continued)