Filter
Top Products
29
Installation Guide
WARNING
p This installation information is designed for professional installers with knowledge of
automobile electrical safety systems and is not intended for non-technical, do-it-yourself
individuals. It does not contain instructions on the electrical installation and avoidance of
potential harm to air bag, anti-theft and ABS braking or other systems necessary to install
this product.
Any attempt to install this product in a motor vehicle by anyone other than a professional
installer could cause damage to the electrical safety system and could result in serious
personal injury or death.
p If your car is equipped with air bag and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the battery to install this product.
Before attempting installation of this electronic component against the manufacturer’s rec-
ommendation, you must contact your car dealer or manufacturer to determine the required
procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT
OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO
THE VEHICLE AND PERSONAL INJURY OR DEATH.
Overview
This product should be installed by a professional.
However, should you decide to install the product
against the manufacturer’s recommendation, these
operating Instructions do not contain electrical
installation instructions. You must contact your
car dealer or manufacturer for electrical connec-
tion instructions to avoid possible damage to your
electrical safety systems and resulting injury or
death. (Please refer to the “WARNING” statement
above).
Your next step is to decide where to install the
unit. The instructions in these pages will guide you
through the remaining steps:
¡ Identify and label the car wires.
¡ Connect the vehicle wires to the wires of the
power connector.
¡ Install the unit in the dashboard.
¡ Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Before you begin installation, look for the following
items which are packed with your unit.
¡ Operating Instructions
¡ Installation hardware .....Needed for Installation.
Dashboard specifications
Min. 4.75 mm {
3
/16"}
Max. 5.56 mm {
7
/32"}
Thickness
53 mm {2-
3
/32
"}
182 mm {7-
5
/32"}
Warning
This unit operates with a 12 V DC negative @
ground auto battery system only. Do not attempt
to use it with any other system. Doing so could
cause serious damage.