Filter
Top Products
24
English
CY-VM7203W
25
English
CY-VM7203W
24
Setting
How to set your ID code (for the fi rst time)
Press [], [], [] or [] to enter an 4 digit
code.
Press [ENT] (ENTER) to set.
Press [], [], [] or [] to enter an 4 digit code
again.
“Complete!” is displayed. The ID code setting is
completed.
How to change your ID code
Press [], [], [] or [] to enter the preset (old)
4 digit code.
Press [], [], [] or [] to enter an new 4 digit
code.
Press [ENT] (ENTER) to set.
Press [], [], [] or [] to enter an 4 digit code
again.
How to cancel the known ID code
Press [], [], [] or [] to enter the preset (old)
4 digit code. If the wrong ID code is entered, it is not
possible to cancel the ID code setting display.
Press and hold [ENT] (ENTER) to cancel the known
ID code.
Note:
Should your unit ever require service, cancel your ID
code before sending for repair.
The inputted code is not displayed for your security.
User Settings (USER)
(continued)
23
Menu
Press [MENU] to display
the menu.
Press [] or [] to select
“USER”.
USER
ID-CODE
ACC SELECT
Submenu
Select
Select
Select
Press [] or [] to select the
item.
Press [ENT] (ENTER).
ID Code Setting
Prior to operating this unit, it is advisable
to assign a 4-digit ID code for security.
Once the ID code has been set, the unit
cannot be operated if the main power supply
is disconnected then re-connected. It is
electrically locked so that a thief cannot use
the stolen unit unless that person knows the
code you have set.
The ID code operation must be performed only
by the person to whom the unit begins.
Generally, it is not necessary to enter the ID
code each time when using the unit if it has
not been disconnected from the main power
supply (car battery).
Default: none
Note:
Press [MENU] in the setting display to return to the
menu display (USER).
Press [] or [] to adjust.
Press [ENT] (ENTER) to set.
See below to set the ID code.
Press [SRC/PWR] to exit the menu.
Caution
Record your registered ID code and keep it in a
secure location. (Fill in the ID code memo. (page
9))
If you forget it, you will be unable to use the unit.
In case you forget the ID code, please consult your
nearest Panasonic Service Center.
ACC Selection ON/OFF
Default: ON
OFF: set to OFF if your car has no ACC position.
ON: set to ON if your car has ACC position.
Note:
You cannot turn on the power via the remote control
when “OFF” is selected in “ACC SELECT”.
(Page 20, 22)
Caution
Be sure to select OFF when your car has no ACC
position in the ignition switch. Failure to do this
could cause the battery to go dead.
[SRC/PWR] (Source)
[MENU]
[SRC] (PWR)
(Source)
[ENT] (ENTER)
[] []
[] []
Menu display (USER)
Note:
Only English is displayed on SCREEN/USER
settings.
Menu-related operations (DISPLAY/USER
settings) can only be carried out from the remote
control unit. They are not possible from the
buttons on the monitor.