Filter
Top Products
14
English
CY-VM7203W
15
English
CY-VM7203W
General
13 14
Power
Turn your car’s ignition key to the ACC or ON position.
ON: Press [SRC/PWR] on the display unit.
Press [SRC] (PWR) on the remote control.
OFF: Press and hold [SRC/PWR] again for more than 1
seconds on the display unit.
Press and hold [SRC] (PWR) again for more than 1
seconds on the remote control.
Note:
You cannot turn on the power via the remote control
when “OFF” is selected in “ACC SELECT”. (page 24)
Source (page 16)
Press [SRC/PWR] to change the source.
AV
VIDEO 1
VIDEO 2
Note:
Select the same source (AV/VIDEO 1/VIDEO 2) as
the terminal that is connected to the optional external
device (AV-IN/VIDEO 1-IN/VIDEO 2-IN).
Volume
[VOL ]: Increase
[VOL ]: Decrease
Setting Range: 0 to 30
Note:
The sound level for each source is stored in memory.
The volume setting must be balanced with the
connected device. Adjust volume from the device side.
Use this unit at close to the default volume level, rather
than at maximum or minimum volume.
Display Open/Close
OPEN: Press [OPEN] (CLOSE).
CLOSE: Press [OPEN] (CLOSE) again.
Note:
When the display unit is opened, “TILT” indicator lights.
If the unit stops halfway, press [OPEN] (CLOSE) again
and draw it all the way in.
Opening/closing the display can also be done when the
power is off (ACC ON).
Warning
Do not touch the unit while the display is moving.
Inserting hands, fi ngers or foreign objects into the
unit can cause injuries and damage to the unit.
Keep babies and children away from the unit.
Display Position Adjustment
Tilt Angle Adjustment (TILT)
Adjustment is operated only be the remote control unit.
Press and hold [TILT] on the display unit for more
than 2 seconds.
Press [] or [] to adjust.
The setup is the same as from MENU. (page 22)
Folding Down the Display
Temporarily
Tip the monitor forward temporarily to operate the
switches and other controls on the back of the monitor.
Fold Down: Press [TILT] on the display unit.
Raise: Press [TILT] again on the display unit.
Note:
Even when the unit is power off, you can fold down the
display temporarily.
Caution
Avoid physical shock on the display.
Do not place any object on the display unit, or
subject it to undue force.
Do not move the display forcibly.
The monitor movable range may be limited by a type
of car, a position where the display is mounted. etc.
Mute
MUTE ON: Press [MUTE].
MUTE OFF: Press [MUTE] again.
[SRC/PWR] (Source/Power) [OPEN] (CLOSE)
[SRC] (PWR)
(Source/Power)
[VOL ] [VOL ] [MUTE]
[TILT]
[]
[]
[VOL ] [VOL ]
[MUTE]
Notes:
Adjust the angle from “Display Unit Adjustment
(DISPLAY UNIT)” of “User Settings (USER)”. (page
22)
Vertical angle (TILT) is saved in the memory, so when
the display unit is drawn out next, it is automatically set
at the angle and in the position adjusted before.
After adjusting its angle, also adjust the brightness as
well. (page 18)
The car model and installation condition may impose
some restrictions on the adjustment of the monitor’s
angle.
15